MOPAR A833 4-SPEED TRANSMISSION & COMPONENT SPECIALISTS

Speedometer pinion hole caplug, fits all 1962 to 1965 A833 4-speeds, and early 727/904 Torqueflite automatic transmissions, keeps dirt and small critters out of your transmission when stored!

Speedometer pinion hole plug, fits all 1966 and later A833 4-speeds, as well as 727/904 Torqueflite automatic transmissions, eliminates the need for the speedometer adapter when not needed in race cars.

New reproduction speedometer pinion adapter for all 1966 & up transmissions (A833, and 904/727 Torqueflite) using 26 to 45 tooth speedometer pinions. New O-ring & inner seal installed.

New reproductin speedometer pinion adapter kit for all 1966 & up transmissions (A833, and 904/727 Torqueflite) using 26 to 45 tooth speedometer pinions. New O-ring & inner seal installed, good used retaining clamp/bolt included.

Speedometer pinion adapter inner seal, seals speedometer pinion shaft to adapter (1966 & later transmissions).

Speedometer pinion adapter inner seal retainer (1966 & later transmissions).

Speedometer pinion adapter seal kit for all 1966 & up transmissions (A833, and 904/727 Torqueflite). Includes 1 each OR3301 o-ring, SS3991 inner seal, and SS3991R seal retainer. (See our SPA66N for new adapter with seal, o-ring and retaining clamp/bolt).

Speedometer pinion adapter seal installation tool, for all 1966 & up transmissions (A833, and 904/727 Torqueflite). Squares and sets the inner seal and retaining clip to the correct depth. Same as Miller specialty tool C-4004.

Specifically formulated for use as an assembly lubricant for all automatic and manual transmissions. It lubricates and helps hold in place needle bearings, thrust washers, sealing rings, "O" rings, hydraulic seals and gaskets during assembly. Remains smooth and stable at working temperatures, and is soluble in all transmission fluids and gear oil. 1 pound plastic tub.

NOS Mopar #2400300 transmission tail shaft seal, correct for 727 torqueflite 1965 1966 1967 1968 1969 1970 1971 and 1966 to 1971 A833 4-speed transmissions (both 23 and 18 spline with 30 spline output shafts). Seal has the correct part number and rolled lip where seal bottoms in the extension housing, as did the production line seal. If you are doing a 100 point restoration on your 426 Hemi Cuda or 440 6-pack car, you need this seal.

Replacement booted tailshaft seal for all 30 spline output 4-speed transmissions, also fits all 727 automatic transmissions. Replaces Mopar #2400300.

Tailshaft seal for 1966-67 A-body transmissions with 26 spline output shafts, 2.25" outside diameter. Replaces Mopar #2400163, fits tailshaft casting #C96706.

Tailshaft seal for overdrive/late A-body transmissions with 26 spline output shafts & 2.375" outside diameter seal. Fits aluminum tailshaft casting #C13364 and #C13386.

Tailshaft seal for all 1964-65 A/B-body transmissions with companion flange.